How do you test the throttle position sensor on a Jeep Grand Cherokee?
Table of Contents
How do you test the throttle position sensor on a Jeep Grand Cherokee?
Using a multimeter, you can test the function of the TPS by probing the signal wire and manually manipulating the throttle. The signal wire should send around one volt with the throttle closed, and close to five when it’s fully open.
How do I test my throttle position sensor?
To check it, touch the negative multimeter probe to the negative wire TPS tab and the positive problem to the positive tab. You should see around 5 volts on the multimeter if everything is working. Now, you should check the signal voltage.
What are the symptoms of a defective throttle position sensor?
An unexplainable bucking and jerking in the vehicle.
Where is the throttle position sensor located on a 2004 Jeep Grand Cherokee?
On the Jeep Grand Cherokee, the TPS is located on top of the engine on the driver’s side of the intake manifold. It is held in place by two Torx screws.
How many volts should a throttle position sensor have?
Although many throttle position sensor voltages are manufacturer-specific, many are non-adjustable and the voltage is in the region of 0.5 to 1.0 volts at idle, rising to 4.0 volts (or more) with a fully opened throttle. For the full operational range, a time scale around 2 seconds is used.
What should TPS voltage be at idle?
When the throttle valve is in idle state or slightly open, the voltmeter should read voltage of 5.0V.
How do I reset my electronic throttle control on my jeep?
Make sure that the accelerator pedal is fully released. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds.
What happens when throttle position sensor fails?
What happens when my throttle position sensor goes bad. When a TPS goes bad, then the car’s throttle body won’t function properly. It could either stay shut or it won’t close properly which is a severe issue. If it stays shut then your engine is not going receive air and it won’t start.
What is the electronic throttle control on a Jeep Grand Cherokee?
An Electronic Throttle Control (ETC) is a technology for automobile vehicles, which connects the gas pedal to your throttle electronically, restoring the mechanical link.
