Where is the IR receiver on my cable box?
Table of Contents
Where is the IR receiver on my cable box?
The IR sensor on the box is a cone-shaped area that is usually behind a dark plastic panel. Use a flashlight to locate it if you are not sure where it is located on your set top box.
What is an IR cable receiver?
IR Receivers These devices pick up infrared signals from your remote control just like a TV or Cable box.
How do I identify an IR Transmitter and receiver?
As mentioned earlier, the circuit is divided into IR transmitter and IR receiver circuits. The infrared rays emitted by the IR Transmitter i.e. IR LED must be detected by the IR Receiver i.e. TSOP 1738. In the transmitter part, the 555 Timer is designed to operate in Astable Mode.
How do you connect IR?
Setup the IR Blaster from the Settings menu
- Turn on the TV and make sure that the set-top box is connected and on.
- On the TV remote, press the HOME button.
- Select Settings.
- The next steps will depend on your TV menu options:
- Connect the IR Blaster.
- Select OK.
How do I know if my IR receiver is working?
You only need to connect a voltmeter to the IR diode and the remote control tester is finished. Set the multimeter so it measures DC voltage and turn it on. Hold the remote control close to the IR diode and push any button. If the remote control is working then the voltage shown on the display will quickly rise.
Where do I plug in the IR Extender cable?
Connect the IR cable to the IR out port on the back of the TV and position the emitter near to the device that you want to control and then select OK to continue. The IR Extender cable relays signals between your TV and other devices.
Is my TV IR or RF?
If the TV does not respond to the button press on the remote, you have an IR remote. If the TV continues to respond to button presses while the front of the remote is covered, you have an RF remote.
Why IR sensor is not working?
First, make sure no physical objects are blocking the path between the remote and the IR sensor on the TV. Try power cycling the TV, too, by uplugging it and letting it rest for 15 minutes before plugging it back in. Don’t rule out the remote, because it may simply need a new pair of batteries.
