Can you use a metal building as a FM antenna?

Can you use a metal building as a FM antenna?

Outside Antennas Sometimes a steel building blocks too much signal to get a good FM reception. If possible, mount an FM antenna on the roof of the building. Install the antenna as high as local regulations will allow and point ti toward the desired broadcast transmitter.

Do Indoor FM antennas work?

Indoor antennas can be a great way to get a small boost to your radio signal when you want a better quality of audio in your home. These devices are usually streamlined and stylish so that you can install them anywhere.

Can I use my cable connection as an FM antenna?

If your cable TV provider supplies FM radio stations, you can pick up the signal through a cable connected to your home theater or stereo receiver. Some receivers are equipped with a coaxial input to connect with a cable. Other models have a pair of spring-clip connectors that hold the two wires for an FM antenna.

Can you use a TV antenna for FM radio?

So if your antenna is designed for UHF/HDTV frequencies only, then it will not receive the FM broadcasts very well. But if it is a combined UHF/VHF antenna, with low-band VHF reception, then you should be able to receive the FM broadcasts.

Will HDTV antenna work on FM?

Most digital television transmissions (including HDTV broadcasts) are in the UHF band (300 MHz to 3,000 MHz). So if your antenna is designed for UHF/HDTV frequencies only, then it will not receive the FM broadcasts very well.

What makes a good FM antenna?

The overall length for the antenna should be about 150 cms, i.e. each leg should be 75 cms. This length should make the resonant frequency fall slightly in the lower half of the FM broadcast band, but often the more popular stations may be found in this region.

Can you use coaxial cable for FM antenna?

There are three types of cable in general use for FM antennas. One is the flat 300-ohm twin- lead cable that has been in use for decades. The second and more popular type is RG59/U 75- ohm coaxial cable.

What is an OTA module?

The DISH Over-the-Air (OTA) Module allows you to add a digital over-the-air tuner to your DISH Wally satellite receiver. This module/tuner gives you the ability to integrate over-the-air channels into the on-screen Program Guide for seamless viewing.

How long should FM wire antenna be?