Does Teck cable need to be bonded at both ends?
Table of Contents
Does Teck cable need to be bonded at both ends?
Cable Armor Bonding When using teck cable, the outer aluminum armor of the cable must also be bonded to ground at both ends.
Where is Teck cable permitted to be installed?
Teck cables with outer jacket may be used for exposed or concealed wiring in wet or dry locations, indoors/outdoors and in corrosive environments. Teck cables are suitable for use in ventilated, non-ventilated and ladder type cable troughs, in ventilated flexible cable ways in both dry and wet locations.
Can you bury Teck connectors?
Teck cable with outer jacket is suitable for direct earth burial and for Class II Division 2, Class III, Divisions 1 and 2 hazardous locations per Canadian Electrical Code. Some of the features of Teck cable are its flexibility and ease of installation.
Do you have to bury Teck cable?
The cable is protected by PVC conduit on all exterior surfaces and for the entire underground section. Must be buried a minimum 18”.
Can you bury a Teck connector?
How deep does Teck cable need to be buried?
Is Teck cable waterproof?
Teck cable is a very versatile power cable because it may be used where subject to limited mechanical damage, it is resistant to water, petrochemicals, and sunlight. It may be used for direct-earth burial and if properly sealed at the connection point, in explosive atmospheres such as gasoline dispensing stations.
Can you run Teck cable on the ground?
Teck cable that contains a blue wire that will be utilized as a white “neutral” requires that wire be identified at both ends, normally done with white electrical tape. The outer jacket must be protected at ground level where it is subject to mechanical damage (see photos pg. 15).
Does Teck cable need mechanical protection?
Armoured cables having an overall outer covering, such as Type ACWU and Type TECK, must be provided with mechanical protection where necessary to ensure the outer covering is not subject to mechanical damage as stated in Rule 12-606.
Does Teck cable have a ground?
TECK90 can be used in open and concealed wiring, direct burial, and in hazardous locations. The insulated conductors are made with cross-linked polyethylene and twisted with an uninsulated ground wire.
Can you bury Teck 90 cable?
Can Teck cable run above ground?
