What is a common collector transistor amp?
Table of Contents
What is a common collector transistor amp?
The Common Collector Amplifier is another type of bipolar junction transistor, (BJT) configuration where the input signal is applied to the base terminal and the output signal taken from the emitter terminal. Thus the collector terminal is common to both the input and output circuits.
What is CC configuration?
Definition: The configuration in which the collector is common between emitter and base is known as CC configuration. In CC configuration, the input circuit is connected between emitter and base and the output is taken from the collector and emitter.
What are the advantages of common collector amplifier?
➢ The common-collector (CC) amplifier is usually referred to as an emitter-follower (EF). The input is applied to the base through a coupling capacitor, and the output is at the emitter. The voltage gain of a CC amplifier is approximately 1, and its main advantages are its high input resistance and current gain.
Why voltage gain in CB amplifier is high?
The volt gain, AV for a collector load resistance of 10kΩ would be: 10,000/25 = 400, and the more current which flows through the junction, the lower becomes its dynamic resistance and the higher the voltage gain. Likewise, the higher the value of load resistance the greater the amplifiers voltage gain.
What are the disadvantages of common collector amplifier?
Common collector circuit has a very high input impedance and very low output impedance so voltage gain provides by this type of circuit is less than 1. Because of that, this type of circuit is not that much suitable for amplification.
Why is it called common-collector?
Common-collector transistor amplifiers are so-called because the input and output voltage points share the collector lead of the transistor in common with each other, not considering any power supplies.
What is the advantage of common-collector amplifier?
What is the use of collector?
In electronics, a common collector amplifier (also known as an emitter follower) is one of three basic single-stage bipolar junction transistor (BJT) amplifier topologies, typically used as a voltage buffer.
