What is my NETGEAR switch password?
Table of Contents
What is my NETGEAR switch password?
Most NETGEAR products: Username for all models: admin. Password for current models: password. Password for older models: 1234.
How do I change my NETGEAR switch password?
To change the admin password on your NETGEAR router:
- Launch a web browser from a device that is connected to your router’s network.
- Enter www.routerlogin.net.
- Enter your user name and password.
- Select ADVANCED > Administration > Set Password.
- Type your current password and type the new password twice.
How do I reset my NETGEAR GS108Ev3?
Disconnect the GS108Ev3 switch from your existing network and make sure its turned on. Get a straightened paper clip. 2. Insert the paper clip to the factory defaults hole then press and hold the factory reset button inside it for 30 seconds.
How do I access NETGEAR GS748T?
Login to the web-GUI of switch. Enter “admin” and “password” as the username and password respectively without the quotation marks. Note: The default IP address of GS748T switch is 192.168. 0.239.
How do I find my password for my NETGEAR wireless router?
In the address bar, type www.mywifiext.net. Log in using your Username and Password. Click Settings then Wireless. Under General, look for WiFi Password.
How do I log into my NETGEAR ProSafe switch?
Open a web browser. Type the IP address of the switch into the address bar of the web browser and press Enter. Type the admin password of the switch (the default password is password) and click Login.
What is the default IP address for NETGEAR switch?
192.168.0.239
In the web browser, enter http://192.168.0.239. This is the default IP address of the switch.
How do I reset my NETGEAR Smart switch?
How do I reset a smart switch to factory default settings?
- In your web browser address field, enter your smart switch IP address.
- Enter your case-sensitive password and click Login.
- Select Maintenance > Reset > Factory Default.
How do I log into my NETGEAR GS110TP?
Type 192.168. 0.239 (the default IP to access the admin interface) in the address bar of your internet browser to access the router’s web-based user interface. You should see 2 text fields where you can enter a username and a password. The default username for your Netgear GS110TP is (blank).
How do I find my NETGEAR managed switch IP address?
In the web browser, enter http://192.168.0.239. This is the default IP address of the switch.
How do I reset my NETGEAR ProSAFE switch?
ProSAFE: Factory reset routers
- Power off device.
- Power up and hold in rear Factory reset button for 10 seconds.
- Release the button.
