What is the difference between foam gun and foam cannon?
Table of Contents
What is the difference between foam gun and foam cannon?
Whereas a Foam Cannon will lay down a thick shaving-cream-like layer of white foam over the entire surface, the Foam Gun with a water hose simply does not have enough water pressure to create such a thick foam, but it will still cover the surface in thick suds to help loosen and lift dirt more easily.
What is the best car wash foam gun?
Best Car Wash Foam Gun for Garden Hose Reviews
- Chemical Guys ACC_326 – Torq Foam Blaster.
- Clean Car USA Foam King Wash Sprayer.
- Adam’s Standard Foam Gun – Car Wash.
- Novosun Car Wash Sprayer.
- SwiftJet Car Wash Foam Gun Sprayer.
- Ordenado Hose Wash Sprayer.
- AgiiMan Car Wash Foam Gun.
- TRKIMAL Car Washing Foam Gun Soap Foam Blaster.
Do foam cannons use a lot of soap?
Foam cannons use quite a bit of soap if you want thick, foamy suds. You’ll find you’re going through your bottle of soap much quicker if you’re foaming your car often.
Is 1.2 gpm good for foam cannon?
Most foam lances require a minimum of ~2 gallons per minute (GPM), but the more basic (and affordable) electric pressure washers are generally around 1.2-1.6 GPM, well below the 2 GPM minimum.
Is 1.2 gpm enough for foam cannon?
How much psi do you need for a foam cannon?
between 1,000 and 3,000 psi
Foam cannons typically require between 1,000 and 3,000 psi. Pressure washers of light to medium duty have a pressure of anywhere from 1,400 to 2,500 psi, so make sure you check your power washer specifications and align them with the specifications of the foam cannon you choose.
How many PSI do you need for a foam cannon?
Foam cannons typically require between 1,000 and 3,000 psi. Pressure washers of light to medium duty have a pressure of anywhere from 1,400 to 2,500 psi, so make sure you check your power washer specifications and align them with the specifications of the foam cannon you choose.
Is 1.4 gpm enough for a foam cannon?
What PSI is best for foam cannon?
30-40 degree nozzle would be safest and size it to hit the PSI you want. You can always tweak PSI of a washer with a different nozzle to be safe. So you recommend 1400-1500 PSI with as many GPM as you can get for car and wheel washing?
What gpm is best for foam cannon?
1.75 GPM is usually enough to output thick foam. Pressure washers with a lower GPM rating will work; the foam will be more of a liquid consistency.
Is 1.2 gpm good for a foam cannon?
Is 1.1 gpm good for foam cannon?
The typical sizes used in a foam cannon are 1.1mm and 1.25mm. They go in the back side of the body assembly (if you remove the pressure washer fitting you will see it). If you are using a pressure washer operating between 1.3 – 1.8 gpm and under 2000 psi a 1.1mm orifice is likely a good starting point.
